Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Explorer Base, 3.5 8, AWD, 6F55FACTORY OEM SERVICE PROCEDURE
Front Lighting Control Module (FLM)
FLM DTC CHART
| DTC | Description | Action |
|---|---|---|
| B10A6:72 | Main Light Switch: Actuator Stuck Open | INSTALL a new FLM. REFER to Front Lighting Control Module (FLM) . |
| B1130:71 | Light switch module: Actuator Stuck | INSTALL a new FLM. REFER to Front Lighting Control Module (FLM) . |
| B11D9:16 | Vehicle Battery: Circuit Voltage Below Threshold | REFER to Diagnostic Routine AE: DTC B11D9:16 . |
| B11D9:17 | Vehicle Battery: Circuit Voltage Above Threshold | REFER to Diagnostic Routine AF: DTC B11D9:17 . |
| U0140:87 | Lost Communication With Body Control Module: Missing Message | REFER to Diagnostic Routine AG: DTC U0140:87 . |
| U0422:86 | Invalid Data Received From Body Control Module: Signal Invalid | DIAGNOSE all non-network DTCs from the BCM. REFER to DTC CHART: BODY CONTROL MODULE (BCM) . |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new FLM. REFER to Front Lighting Control Module (FLM) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
