Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Explorer Base, 2.0 9FACTORY OEM SERVICE PROCEDURE
General Procedure
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Establish a scan tool session.
- Turn ignition to RUN.NOTE: For Intelligent Access (IA) vehicles, REFER to PUSH-BUTTON START - WITH INTELLIGENT ACCESS , RUN.
If the RFA module has been replaced, it may not be possible to put the ignition in RUN. The RFA module can communicate with a scan tool with the ignition in the OFF state .
- The scan tool first attempts to communicate with the PCM . After establishing communication with the PCM , the scan tool then attempts to communicate with all other modules on the vehicle.
- If an IDS session cannot be established with the vehicle, IDS may state "No communication can be established with the PCM ."
- Choose "NO" when the scan tool prompts whether or not to retry communication.
- Enter either a PCM part number, tear tag or calibration number to identify the vehicle and start a session. The PCM part number and 4-character tear tag number are printed on the PCM label. If the PCM part number cannot be found, a base part number search on the HVBOM application (under the OASIS tab on the technician service publication website) retrieves the PCM part number.
- REFER to PINPOINT TEST A .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
