2012 Ford Explorer Base, 2.0 9FACTORY OEM SERVICE PROCEDURE

Pinpoint Test

  1. CHECK FOR ACCESSORY DRIVE BELT NOISE AND LOOSE MOUNTING BRACKETS
    1. Ignition OFF.
    2. Check the accessory drive belt and tensioner for damage and correct installation. REFER to ACCESSORY DRIVE BELT or REFER to ACCESSORY DRIVE BELT TENSIONER .
    3. Check the accessory mounting brackets and generator pulley for looseness or misalignment.

    Is the accessory drive OK? 

    1. Yes: GO to 2  .
    2. No: REPAIR as necessary. REFER to SYMPTOM CHART: FRONT END ACCESSORY DRIVE (FEAD) for diagnosis and testing of the accessory drive system.
  2. CHECK THE GENERATOR MOUNTING
    1. Check the generator mounting for loose bolts or misalignment.

    Is the generator mounted correctly? 

    1. Yes: GO to 3  .
    2. No: REPAIR as necessary.
  3. CHECK THE GENERATOR FOR NOISE
    1. With the engine running, use a stethoscope or equivalent listening device to probe the generator and the accessory drive area for unusual mechanical noise.

    Is the generator the noise source? 

    1. Yes: INSTALL a new generator. REFER to Generator - 3.5L Ti-VCT  or Generator - 2.0L GTDI .
    2. No: REFER to SYMPTOM CHART(S) : NVH to diagnose the source of the engine noise.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.