Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Explorer Base, 2.0 9FACTORY OEM SERVICE PROCEDURE
Programming the Autolock Feature Using the Keyless Entry Keypad
- Place the ignition to the OFF mode and close all vehicle doors.
- Enter the factory set 5-digit keyless entry keypad code.
- Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.
- Release the 7/8 button, then release the 3/4 button. The horn chirps once if autolock is disabled or twice (one short chirp followed by a honk) if autolock is enabled.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.