2012 Ford Expedition 2WD V8-5.4LFACTORY OEM SERVICE PROCEDURE

Fuel Tank Pressure Sensor: Service and Repair




Fuel Tank Pressure Sensor

106L (28 Gal) Fuel Tank

Factory service manual diagram




Factory service manual diagram





127L (33.5 Gal) Fuel Tank

Factory service manual diagram




Factory service manual diagram




Removal and Installation

All fuel tanks

1. Remove the fuel tank.

2. Disconnect the fuel supply tube-to-heat shield pushpin retainer.

127L (33.5 gal) fuel tank

3. Remove the fuel tank heat shield retainer(s).

All fuel tanks

4. Remove the fuel tank heat shield.

5. Disconnect the Fuel Tank Pressure (FTP) sensor and vapor tube assembly-to-fuel vapor/grade vent valves quick connect couplings. For additional information, refer to Fuel Delivery and Air Induction.

6. Disconnect the FTP (Fuel Tank Pressure) sensor and vapor tube assembly-to-fuel pump module quick connect coupling. For additional information, refer to Fuel Delivery and Air Induction.

7. Remove the FTP (Fuel Tank Pressure) sensor and vapor tube assembly from the fuel tank.

8. To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test Testing and Inspection.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.