2012 Ford Escape XLS, FWDFACTORY OEM SERVICE PROCEDURE

Section 15 (Power Transfer Unit): Specifications

WARNING: This page is about a different variant/trim than selected.
MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada)
WSL-M2C192-A and GL-5 0.35L (12 oz)
Silicone Gasket and Sealant
TA-30
WSE-M4G323-A4 -
GENERAL SPECIFICATIONS

Item Specification
Power Transfer Unit (PTU) Case Vent 
Installed height mm (in) (1)
(1) Refer to the appropriate procedures in this service information.
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Catalytic converter bracket bolts 25 18 -
Catalytic converter bracket nuts 36 27 -
Crossmember brace bolts 40 30 -
Fill plug 34 25 -
Power Transfer Unit (PTU) cover bolts(1) - - -
PTU bracket-to-engine bolt 48 35 -
PTU bracket-to-PTU bolt 48 35 -
PTU-to-transaxle bolts 70 52 -
PTU-to-transaxle bolt (M10) 47 35 -
Transfer case vent tube bolt 22 16 -
(1) Refer to the appropriate procedure in this service information.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.