Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Escape XLS, FWDFACTORY OEM SERVICE PROCEDURE
DTC Chart
PCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position | CARRY OUT the Ignition Switch Component Test. Refer to OEM COMPONENT TESTING -- ESCAPE article or OEM COMPONENT TESTING -- ESCAPE HYBRID article for component testing. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power. |
| P0706 | TR sensor A circuit range/performance | Refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
| P0707 | TR sensor A circuit low | Refer to Section AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
| P0708 | TR sensor A circuit high | Refer to Section AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
| P1260 | Theft detected, vehicle immobilized | REFER to the DTC Chart in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) - HYBRID article. |
| P1702 | TR sensor A circuit failure | Refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
| P1705 | TR Not indicating PARK/NEUTRAL during Self-Test | Refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
| P1921 | TR Signal | Refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
