2012 Ford Escape XLS, AWDFACTORY OEM SERVICE PROCEDURE

Removal and Installation

Fig 1: Identifying 4X4 Control Module And Electrical Connector
G06098371Courtesy of FORD MOTOR CO.
Item Part Number Description
1 7H473 4X4 control module
2 - Electrical connector (part of 14405)
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Disconnect the electrical connector.
  3. Lift upward on the module to release the fasteners from the shifter base. Remove the 4X4 control module.
  4. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.