2012 Ford Escape XLS, AWDFACTORY OEM SERVICE PROCEDURE

Transfer Case Vent: Installation

  1. Inspect the condition of the PTU vent hole.
    • By hand, insert the new PTU vent into the PTU cover and measure the distance between the PTU cover and the vent as indicated.
    • If the measurement is less than specification, install a new PTU.
      Fig 1: Identifying PTU Vent Hole Dimension
      G06098392Courtesy of FORD MOTOR CO.
  2. NOTE: Do not apply silicone sealant to the Power Transfer Unit (PTU) vent hole as it may cause damage to the PTU internal components.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.