Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Escape XLS, AWDFACTORY OEM SERVICE PROCEDURE
Cover Seal: Notes
SPECIAL TOOLS CHART
| Bearing Cup Remover 303-D021 |
|
| Handle 205-153 (T80T-4000-W) |
|
| Installer, Halfshaft Oil Seal 308-431 |
|
| Installer, PTO Driven Gear Oil Seal 308-429 |
|
| Installer, Rear Axle Oil Seal 205-155 (T80T-4000-Y) |
|
| Remover, Halfshaft 205-241 |
|
| Slide Hammer 100-001 (T50T-100-A) |
| Item | Part Number | Description |
|---|---|---|
| 1 | 7H459 | Deflector |
| 2 | 7H426 | Cover seal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.