2012 Ford Escape XLS, AWDFACTORY OEM SERVICE PROCEDURE

Hydraulic Control Unit (HCU): Notes

SPECIAL TOOLS CHART

G07938106
Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
Fig 1: Hydraulic Control Unit Components With Torque Specifications
G07938107Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W712119 Hydraulic Control Unit (HCU) bracket-to-frame bolt (3 required)
2 2C215 HCU
3 - Master cylinder secondary brake tube fitting (part of 2268)
4 - Master cylinder primary brake tube fitting (part of 2268)
5 - LH front brake tube fitting (part of 2264)
6 - RH front brake tube fitting (part of 2263)
7 - Rear brake tube fittings (part of 2267)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.