2012 Ford Econoline Base, Van CargoFACTORY OEM SERVICE PROCEDURE

Component testing procedure

WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART

Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
Turn signal From C202A cavity 1 to C202A cavity 2 Hazard switch to Normal (Off) and Turn switch to Left Closed circuit
From C202A cavity 1 to C202A cavity 3 Hazard switch to Normal (Off) and Turn switch to Right Closed circuit
Hazard From C202A cavity 10 to C202A cavity 6 Hazard switch to Hazard (On) (Button pushed in and then released to fully extended position) Closed circuit
Flash-to-pass From C202B cavity 11 to cavity 10 Pull and hold lever stalk toward steering wheel Closed circuit
High beam From C202B cavity 9 to C202B cavity 10 Lever stalk in detent away from steering wheel Closed circuit
Low beam From C202B cavity 9 to C202B cavity 10 and from C202B cavity 11 to C202B cavity 10 Lever stalk in neutral position toward steering wheel Open circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.