Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Ford Econoline Base, Van CargoFACTORY OEM SERVICE PROCEDURE
Component testing procedure
WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Off | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Off/Mist | Open at all cavities. |
| Int 1 | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Int 1 | Closed at cavity 4, open at all other cavities |
| Int 2 | C202C cavity 5, and C202C cavities 1, 2, 3, 4, and 6 | Int 2 | Closed at cavities 3 and 4, open at all other cavities. |
| Int 3 | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Int 3 | Closed at cavity 3, open at all other cavities. |
| Int 4 | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Int 4 | Closed at cavities 3 and 6, open at all other cavities. |
| Int 5 | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Int 5 | Closed at cavity 6, open at all other cavities. |
| Low | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Low | Closed at cavities 4 and 6, open at all other cavities |
| High | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | High | Closed at cavities 1, 4, and 6, open at all other cavities. |
| Wash-w/CKT 680 | C202 cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Wash | Closed at cavity 2, open at cavity 1, any state at other cavities. |
| Wash-w/o CKT 680 | C202C cavity 5 and C202C cavities 1, 2, 3, 4, and 6 | Wash | Closed at cavities 3, 4, and 6, open at all other cavities. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
