2012 Ford Econoline Base, Van CargoFACTORY OEM SERVICE PROCEDURE

Component testing procedure

WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART

Circuit to test Connect self-powered test light or ohmmeter to terminals Move key to these positions A good switch will indicate
Run/Accessory power circuit 7 and 3 Accessory Closed circuit
Lock/Off/Run/Start Open circuit
Β  9 and 3 Accessory/Lock/Off Open circuit
Run Closed circuit
Start Open circuit
Run power circuit 2 and 8 12 and 13 Accessory/Lock/Off Open circuit
Run Closed circuit
Start Open circuit
Run/Start power circuit 7 and 1 Accessory/Lock/Off Open circuit
Run/Start Closed circuit
Start power circuit 2 and 5 Accessory/Lock/Off/Run Open circuit
Start Closed circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.