WARNING: This page is about a different variant/trim than selected.

As-Built data is a VIN-specific module configuration record. During vehicle build, the configuration from all modules is downloaded and stored in the As-Built database. As-Built data does not reflect customer preference items that have been changed from the default state. These items need to be changed using programmable parameters after the module is configured.

NOTE: It is not necessary to obtain As-Built data unless directed to do so by the scan tool. This data may be accessed from the technician service publication website.

MODULE CONFIGURATION AND PARAMETER CHART

Module	Module Address	Requires PMI	Reprogram/ Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ABS module with Roll Stability Control (RSC®)	760	No	Yes	Interactive vehicle dynamics initialization	None
ABS module without RSC®	760	Yes	Yes	No	None
Accessory Protocol Interface Module (APIM) (if equipped)	7D0	Yes	Yes	No	Stereo-In pass through
Audio Control Module (ACM)	727	Yes	Yes	No	Speakers (Navigation only) Rear camera (Navigation only)
Global Positioning System Module (GPSM) (if equipped)	701	No	Yes	No	None
Instrument Panel Cluster (IPC)	720	Yes	Yes	None	Auto locking Auto-unlocking Belt-Minder® English/metric default Language
Parking Aid Module (PAM)	736	Yes	No	No	None
PCM	7E0	Yes	Yes	Adaptive airflow Idle speed Refueling event Fuel trim Misfire monitor profile correction Transmission adaptive shift pressure	Axle ratio Tire size Engine only traction control Speed control
Restraints Control Module (RCM)	737	Yes	Yes	No	Beltminder
Satellite Digital Audio Receiver System (SDARS) module (if equipped)	782	Yes	Yes	No	None
Smart Junction Box (SJB) (except stripped chassis)	726	Yes	Yes	Tire Pressure Monitoring System (TPMS) sensor calibration	Auto locking Auto-unlocking Daytime Running Lamps (DRL) present Locking light feedback Locking horn feedback Police dark car Smart unlocking Stoplamps outage Tire placard pressure Turn lamps outage
Trailer Brake Control (TBC) module	757	No	No	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

As-Built Data

Use the Manual With the Right Hardware

When to See a Mechanic