2012 Ford Econoline Base, Van CargoFACTORY OEM SERVICE PROCEDURE

Engine Controls - Electronic Engine Controls: Specifications

MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
High Temperature Nickel Anti-Seize Lubricant
XL-2
ESE-M12A4-A -
Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil
XO-5W20-QSP (US); Motorcraft SAE 5W-20 Super Premium Motor Oil CXO-5W20-LSP12 (Canada); or equivalent
WSS-M2C930-A -
Penetrating and Lock Lubricant (US); Penetrating Fluid (Canada)
XL-1 (US); CXC-51-A (Canada)
- -
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
A/C compressor bolts 25 18 -
Camshaft Position (CMP) sensor bolt 10 - 89
Catalyst Monitor Sensor (CMS) 46 34 -
Crankshaft Position (CKP) sensor bolt 10 - 89
Cylinder Head Temperature (CHT) sensor 26 19 -
Heated Oxygen Sensor (HO2S) 46 34 -
Knock Sensor (KS) bolt 25 18 -
Mass Air Flow (MAF) sensor screws 2 - 18
PCM nuts 7 - 62
Throttle Position (TP) sensor screws 3 - 27
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.