Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Transit Connect Van CargoFACTORY OEM SERVICE PROCEDURE
Generic Electronic Module (GEM)
GENERIC ELECTRONIC MODULE (GEM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1438 | Wiper Mode Select Switch Circuit Failure | GO to PINPOINT TEST C . |
| B1439 | Wiper Mode Select Switch Circuit Open | GO to PINPOINT TEST G . |
| B1446 | Wiper Park Sense Circuit Failure | GO to PINPOINT TEST H . |
| B1611 | Wiper Rear Mode Select Switch Circuit Failure | GO to PINPOINT TEST B . |
| B2114 | Front Washer Input Short to Ground | GO to PINPOINT TEST I . |
| B2115 | Rear Washer Input Short to Ground | GO to PINPOINT TEST I . |
| B211A | Front Wiper Motor Relay Circuit Short To Ground | GO to PINPOINT TEST H . |
| All Other DTCs | - | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULE article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.