Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Transit Connect L4-2.0LFACTORY OEM SERVICE PROCEDURE
Test HC: Fuel Delivery System
PINPOINT TEST HC: FUEL DELIVERY SYSTEM
Warnings:
Warning, Note And Fuel System Specification Chart (Ignition ON, Engine OFF Values):
Inertia Fuel Shutoff (IFS) Switch - Reset Instructions And Fuel Pump (FP) Connector:
Fuel Pump (FP) Connector:
HC1-HC2:
HC3-HC4:
HC5:
HC6:
HC7:
HC8-HC10:
HC11-HC13:
HC14-HC15:
HC16-HC18:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.