2011 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE

Rear View Mirror DTCS

DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1667 Mirror Driver Up/Down Motor Stalled GO to PINPOINT TEST E .
B1668 Mirror Driver Right/Left Motor Stalled GO to PINPOINT TEST E .
B1733 Mirror Driver Vertical Switch Circuit Failure GO to PINPOINT TEST E .
B1737 Mirror Driver Horizontal Switch Circuit Failure GO to PINPOINT TEST E .
B1741 Mirror Passenger Vertical Switch Circuit Failure GO to PINPOINT TEST E .
B1745 Mirror Passenger Horizontal Switch Circuit Failure GO to PINPOINT TEST E .
B2223 Mirror Driver Drive Circuit Failure GO to PINPOINT TEST E .
B2320 Mirror Driver Horizontal Feedback Potentiometer Circuit Failure GO to PINPOINT TEST E .
B2322 Mirror Driver Horizontal Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST E .
B2324 Mirror Driver Vertical Feedback Potentiometer Circuit Failure GO to PINPOINT TEST E .
B2326 Mirror Driver Vertical Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST E .
All other DTCs - REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS Article.
DRIVER SEAT MODULE (DSM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1669 Mirror Passenger Up/Down Motor Stalled GO to PINPOINT TEST E .
B1670 Mirror Passenger Right/Left Motor Stalled GO to PINPOINT TEST E .
B2224 Passenger Mirror Drive Circuit Failure GO to PINPOINT TEST E .
B2312 Passenger Mirror Horizontal Feedback Potentiometer Circuit Failure GO to PINPOINT TEST E .
B2314 Passenger Mirror Horizontal Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST E .
B2316 Passenger Mirror Vertical Feedback Potentiometer Circuit Failure GO to PINPOINT TEST E .
B2318 Passenger Mirror Vertical Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST E .
All other DTCs - REFER to SEAT SYSTEM - SEATS Article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.