Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Steering Column Switches DTCS
REMOTE FUNCTION ACTUATOR (RFA) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B108A:11 | Start Button: Circuit Short to Ground | GO to PINPOINT TEST G . |
| B108A:15 | Start Button: Circuit Short to Battery or Open | GO to PINPOINT TEST G . |
| B10E7:11 | Ignition On Relay: Circuit Short to Ground | GO to PINPOINT TEST H . |
| B10E7:12 | Ignition On Relay: Circuit Short to Battery | GO to PINPOINT TEST H . |
| B10E7:13 | Ignition On Relay: Circuit Open | GO to PINPOINT TEST H . |
| U3004:11 | Accessory Power Relay: Circuit Short to Ground | GO to PINPOINT TEST I . |
| U3004:12 | Accessory Power Relay: Circuit Short to Battery | GO to PINPOINT TEST I . |
| U3004:13 | Accessory Power Relay: Circuit Open | GO to PINPOINT TEST I . |
| - | All Other Remote Function Actuator (RFA) Module DTCs | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULE Article. |
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B2A20 | Ignition Stuck in START | Vehicles with an ignition switch, GO to PINPOINT TEST E
. Vehicles with a push button start system, GO to PINPOINT TEST L . |
| B2844 | Ignition Fault | Vehicles with an ignition switch, GO to PINPOINT TEST F
. Vehicles with a push button start system, GO to PINPOINT TEST M . |
| U2472 | Unexpected Ignition State | Vehicles with an ignition switch, GO to PINPOINT TEST F
. Vehicles with a push button start system, GO to PINPOINT TEST M . |
| - | All Other SJB DTCs | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULE Article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
