2011 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Component testing procedure

WARNING: This page is about a different car, the 2011 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
EXTERIOR REAR VIEW MIRROR SWITCH - COMPONENT TESTING

Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
Left mirror   Selector switch left  
Up 1 and 6
3 and 5
Up Closed circuit
Down 1 and 5
3 and 6
Down Closed circuit
Left 1 and 8
3 and 6
Left Closed circuit
Right 1 and 6
3 and 8
Right Closed circuit
Right mirror   Selector switch right  
Up 1 and 6
3 and 2
Up Closed circuit
Down 1 and 2
3 and 6
Down Closed circuit
Left 1 and 7
3 and 6
Left Closed circuit
Right 1 and 6
3 and 7
Right Closed circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.