Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Dual Climate Controlled Seat Module (DCSM)
Dual Climate Controlled Seat Module (DCSM)
Removal and Installation
NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.
1. When installing a new Dual Climate Controlled Seat Module (DCSM), carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration Programmable Module Installation (PMI).
2. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.
Turn the ignition OFF and wait at least one minute.
3. From under the front passenger seat, remove the DCSM in the following sequence.
1. Remove the screws.
2. Release the locking wedges on the 2 DCSM electrical connectors.
3. Disconnect the electrical connectors.
4. Remove the DCSM.
4. To install, reverse the removal procedure.
5. If a new DCSM has been installed, carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration Programmable Module Installation (PMI).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.