Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Sunshade Module
Sunshade Module
Removal and Installation
1. Remove the rear seat. For additional information, refer to Seating Rear Seat.
2. Remove the parcel shelf. For additional information, refer to Parcel Shelf Service and Repair.
3. Disconnect the sunshade module electrical connector.
4. Press the tabs on the sunshade module to release the sunshade module from the sunshade module bracket.
5. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.