2011 Ford Taurus AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Service and Repair




Window Control Switch

Removal and Installation

NOTE: Driver front shown, all others similar.

Factory service manual diagram




Factory service manual diagram




1. Remove the window control switch.
- Using a suitable tool, gently pry the regulator control switch bezel up at the rear to release the retaining clip.

- Position the switch assembly rearward to unlock the front locking tab.

- Disconnect the electrical connector.

2. To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.