2011 Ford Taurus AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Ignition Switch: Service and Repair




Ignition Switch

Factory service manual diagram




Factory service manual diagram




Removal and Installation

1. Remove the ignition lock cylinder housing. For additional information, refer to Handles, Locks, Latches and Entry Systems Ignition Lock Cylinder Housing.

2. Push the 2 locking tabs inward and remove the ignition switch.

3. To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.