Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Taurus AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold Absolute Pressure (MAP) / Intake Air Temperature 2 (IAT2) Sensor
Removal
NOTE: The Turbocharger Boost Pressure (TCBP)/Charge Air Cooler Temperature (CACT) sensor and the Manifold Absolute Pressure (MAP)/ Intake Air Temperature 2 (IAT2) sensor are not interchangeable.
1. Disconnect the MAP/ IAT2 sensor electrical connector.
2. Remove the 2 screws and the MAP/ IAT2 sensor.
Installation
1. Lubricate the MAP/ IAT2 sensor O-ring seal with clean engine oil.
2. Install the MAP/IAT2 sensor and the 2 screws.
- Tighten to 6 Nm (53 lb-in).
3. Connect the MAP/ IAT2 sensor electrical connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
