2011 Ford Ranger 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair




Crankshaft Position (CKP) Sensor - 2.3L

Factory service manual diagram




Factory service manual diagram




Factory service manual diagram




Factory service manual diagram




Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.

3. Remove the engine plug bolt.

Factory service manual diagram




4. Install the Crankshaft Timing Peg and turn the crankshaft pulley bolt to position the No. 1 cylinder at Top Dead Center (TDC).

Factory service manual diagram




5. Remove the 2 bolts and the CKP sensor.

6. Install the 6 mm x 18 mm bolt in the position shown.

Factory service manual diagram




Installation

1. NOTE: Whenever the CKP sensor is removed, a new one must be installed using the Crankshaft Sensor Aligner.

Position the CKP sensor and loosely install the 2 bolts.

2. Adjust the CKP sensor with the Crankshaft Sensor Aligner and tighten the 2 bolts.
- Tighten to 7 Nm (62 lb-in).

Factory service manual diagram




3. Connect the CKP sensor electrical connector.

4. Remove the 6 mm x 18 mm bolt.

Factory service manual diagram




5. Remove the Crankshaft Timing Peg.

Factory service manual diagram




6. Install the engine plug bolt.
- Tighten to 20 Nm (177 lb-in).

Factory service manual diagram




Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.