2011 Ford Ranger 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE

Ride Height Measurement




Ride Height Measurement


Front Ride Height Measurement

Factory service manual diagram





Factory service manual diagram




NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

1. Position a suitable surface gauge (such as Starrett 57D Surface Gauge), on a flat, level surface and adjust the gauge's arm until the scriber point is located in the center of the lower arm rearward bolt.
- Lock the surface gauge in this position.

Factory service manual diagram




2. With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 2).

Factory service manual diagram




3. Position the surface gauge on the same flat, level surface as used in Step 1, adjust the gauge's arm until the scriber point is located on the wheel knuckle lowest point, behind the lower ball joint nut.
- Lock the surface gauge in this position.

Factory service manual diagram




4. With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 3).

Factory service manual diagram




5. Subtract measurement 3 from measurement 2 to obtain the front ride height.
- Refer to Specifications.


Rear Ride Height Measurement

Ride Height Measurement - Four-Wheel Drive (4WD)

Factory service manual diagram




Factory service manual diagram





Ride Height Measurement - Rear Wheel Drive (RWD)

Factory service manual diagram




Factory service manual diagram




NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

1. To obtain rear ride height, measure the distance between points 2 and 3. For additional information, refer to Specifications.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.