2011 Ford Ranger 2D Pickup, StandardFACTORY OEM SERVICE PROCEDURE

Inspection and Verification

WARNING: This page is about a different car, the 2009 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

This section provides step-by-step module configuration procedures. Carry out the PROGRAMMABLE MODULE INSTALLATION (PMI)  procedures when another Service Information article directs you to carry out configuration or when DTCs from the below list are present:

DTC CHART

DTC Description Source Action
B2477 Module Configuration Failure
  • Instrument Cluster (IC)
  • Satellite Digital Audio Receiver System (SDARS) module
  • Smart Junction Box (SJB)
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
B2477 Module Configuration Failure
  • Restraints Control Module (RCM)
INSTALL a new RCM  . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
P0602 Powertrain Control Module Programming Error
  • PCM
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605 Internal Control Module Read Only Memory (ROM  ) Error
  • PCM
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300 Internal Control Module Software Incompatibility
  • PCM
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0301 Software Incompatibility with Engine/Powertrain Control Module
  • PCM
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • IC 
  • Occupant Classification System Module (OCSM)
  • SDARS  module
  • SJB 
  • 4X4 control module
CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • RCM 
INSTALL a new RCM  . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
U2051 One or More Calibration Files Missing/Corrupt
  • RCM 
INSTALL a new RCM  . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.