2011 Ford Ranger 2D Pickup, AutomaticFACTORY OEM SERVICE PROCEDURE

Module Configuration System DTCS

DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Instrument Cluster (IC)
  • Satellite Digital Audio Receiver System (SDARS) module
  • Smart Junction Box (SJB)
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
B2477 Module Configuration Failure
  • Restraints Control Module (RCM)
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article.
P0602 Powertrain Control Module Programming Error
  • PCM
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605 Internal Control Module Read Only Memory (ROM) Error PCM
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300 Internal Control Module Software Incompatibility
  • PCM
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0301 Software Incompatibility with Engine/Powertrain Control Module
  • PCM
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • IC
  • Occupant Classification System Module (OCSM)
  • SDARS module
  • SJB
  • 4X4 control module
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • RCM
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article.
U2051 One or More Calibration Files Missing / Corrupt
  • RCM
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.