2011 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Body Control Module B (BCM-B)

BODY CONTROL MODULE B (BCM-B) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1267:11 Convertible/Folding Top Activation Up Switch: Circuit Short to Ground GO to PINPOINT TEST A .
B1268:11 Convertible/Folding Top Activation Down Switch: Circuit Short to Ground GO to PINPOINT TEST A .
B1269: 11 Convertible/Folding Top Fully Up Position Switch: Circuit Short to Ground REFER to WINDOWS & GLASS - GLASS, FRAMES & MECHANISMS article.
B126D: 15 Convertible/Folding Top Fully Down Position Switch: Circuit Short to Battery or Open REFER to WINDOWS & GLASS - GLASS, FRAMES & MECHANISMS article.
B126E:23 Right Rear Window Fully Down Feedback: Signal Stuck Low CLEAR the DTCs. TEST the system for normal operation. REPEAT the self-test. If DTC B126E: 23 returns, GO to PINPOINT TEST A .
B126E:24 Right Rear Window Fully Down Feedback: Signal Stuck High CLEAR the DTCs. TEST the system for normal operation. REPEAT the self-test. If DTC B126E: 24 returns, GO to PINPOINT TEST A .
B126F:23 Left Rear Window Fully Down Feedback: Signal Stuck Low CLEAR the DTCs. TEST the system for normal operation. REPEAT the self-test. If DTC B126F: 23 returns, GO to PINPOINT TEST A .
B126F:24 Left Rear Window Fully Down Feedback: Signal Stuck High CLEAR the DTCs. TEST the system for normal operation. REPEAT the self-test. If DTC B126F: 24 returns, GO to PINPOINT TEST A .
B1278:12 Convertible/Foldable Top Up Relay: Circuit Short to Battery GO to PINPOINT TEST A .
B1278:14 Convertible/Foldable Top Up Relay: Circuit Short to Ground or Open GO to PINPOINT TEST A .
B1279:12 Convertible/Foldable Top Down Relay: Circuit Short to Battery GO to PINPOINT TEST A .
B1279:14 Convertible/Foldable Top Down Relay: Circuit Short to Ground or Open GO to PINPOINT TEST A .
B127A: 12 Global Window Control: Circuit Short to Battery REFER to WINDOWS & GLASS - GLASS, FRAMES & MECHANISMS article.
B127A: 14 Global Window Control: Circuit Short to Ground or Open REFER to WINDOWS & GLASS - GLASS, FRAMES & MECHANISMS article.
All Other DTCs - REFER to MULTIFUNCTION ELECTRONIC MODULE article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.