Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front End Accessory Drive (FEAD) belt tensioner bolt | 25 | 18 | - |
| Generator B+ terminal nut | 17 | - | 150 |
| Generator bolt | 48 | 35 | - |
| Generator clutch pulley | 75 | 55 | - |
| Generator stud (5.0L) | 8 | - | 71 |
| Generator stud nut (3.7L/5.0L) | 48 | 35 | - |
| Lower generator stud bolt (5.4L) | 48 | 35 | - |
| Power steering tube bracket nut (5.4L) | 25 | 18 | - |
| Stabilizer bar bracket nuts | 70 | 52 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.