2011 Ford Fusion FWD L4-2.5LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Service and Repair




Window Control Switch

Fusion, Milan

NOTE: LH front shown, all others similar.

Factory service manual diagram





Factory service manual diagram





MKZ - Front Door

NOTE: LH front shown.

Factory service manual diagram





Factory service manual diagram





MKZ - Rear Door

NOTE: RH rear shown.

Factory service manual diagram





Factory service manual diagram





Removal and Installation

Fusion, Milan

1. Remove the access cover and the screw.

2. Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.

Factory service manual diagram




MKZ

3. NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.

All Vehicles

4. Disconnect the electrical connector(s).

5. Remove the window control switch.

6. To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.