Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Focus SES, AutomaticFACTORY OEM SERVICE PROCEDURE
Starting System DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position | CARRY OUT the Ignition Switch Component Test. Refer to IGNITION SWITCH Wiring Diagrams Cell 149 for component testing. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power. |
| P0705 | Transmission Range (TR) Sensor Circuit Failure | Refer to Group 307 for the TRANSMISSION RANGE (TR) SENSOR ADJUSTMENT appropriate procedure |
| P1702 | TR Sensor Circuit Failure | Refer to the TRANSMISSION RANGE (TR) SENSOR ADJUSTMENT appropriate section in Group 307 for the procedure. |
| P1705 | TR Sensor Circuit Failure | Refer to the TRANSMISSION RANGE (TR) SENSOR ADJUSTMENT appropriate section in Group 307 for the procedure. |
| P0830 | Clutch Pedal Switch A Circuit | REFER to INTRODUCTION - GASOLINE MODELS . |
| P0833 | Clutch Pedal Switch B Circuit | REFER to INTRODUCTION - GASOLINE MODELS . |
| P1260 | Theft Detected, Vehicle Immobilized | REFER to the DTC Table in DTC CHARTS . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.