2011 Ford Focus SES, AutomaticFACTORY OEM SERVICE PROCEDURE

Module Configuration System DTCS

DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Audio Control Module (ACM)
  • Front Display Interface Module (FDIM)
  • Instrument Cluster (IC)
  • Restraints Control Module (RCM)
  • Smart Junction Box (SJB)
 CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
B2900 VIN Mismatch
  • ABS module
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0602 Powertrain Control Module Programming Error
  • PCM
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605 Internal Control Module Read Only Memory (ROM) Error
  • PCM
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300 Internal Control Module Software Incompatibility
  • PCM
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • ABS module
  • ACM
  • Front Controls Interface Module (FCIM)
  • FDIM
  • IC
  • Occupant Classification System Module (OCSM)
  • PCM
  • RCM
  • SJB
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • HVAC module
 INSTALL a new HVAC module. REFER to HEATING VENTILATION AIR CONDITIONING (HVAC) MODULE .
U2051 One or More Calibration Files Missing/Corrupt
  • ACM
  • FCIM
  • FDIM
  • RCM
  • OCSM
  • PCM
 CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • APIM
 CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information
  • APIM
 CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.