2011 Ford Flex SEFACTORY OEM SERVICE PROCEDURE

Receiver Drier: Notes

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS

Item Specification
Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D
WSH-M1C231-B
Fig 1: Receiver Drier And Replacement Components With Torque Specifications
G08043573Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W520413 Condenser outlet fitting nut
2 W520413 Receiver/drier outlet fitting nut
3 W703845 Receiver/drier bolt (2 required)
4 19C836 Receiver/drier
5 19959 O-ring seal and gasket seal kit (2 required)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.