WARNING: This page is about a different car, the 2011 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.

WIPER/WASHER SWITCH - COMPONENT TESTING

Circuit to test	Connect self-powered test light or ohmmeter to terminals	Move switch to these positions	A good switch will indicate
Front washer switch circuit	1 and 8	Wash	Closed circuit
Front washer switch circuit	1 and 8	Rest	Open circuit
Rear washer switch circuit	4 and 8	Wash	Closed circuit
Rear washer switch circuit	4 and 8	Rest	Open circuit
Front wiper high circuit	2 and 3	High	Closed circuit
Front wiper high circuit	2 and 3	All positions except high	Open circuit
Front wiper low circuit	6 and 3	Single pass	Closed circuit
		Low	Closed circuit
		All positions except low or single pass	Open circuit
Front wiper single pass circuit	6 and 3	Single pass	Closed circuit
		Low	Closed circuit
		All positions except low or single pass	Open circuit
Front wiper intermittent circuit	12 and 3	Intermittent	Closed circuit
Front wiper intermittent circuit	12 and 3	All positions except intermittent	Open circuit
Rear wiper circuit	5 and 3	Off	Open circuit
		On	Closed circuit
		Wash	Closed circuit

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Component testing procedure

Use the Manual With the Right Hardware

When to See a Mechanic