Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Flex FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Driver Seat Module (DSM)
Driver Seat Module (DSM)
Removal and Installation
1. NOTE: This step is necessary only if the Driver Seat Module (DSM) is being replaced.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information must be downloaded into the new module after installation. For additional information, refer to Module Configuration Testing and Inspection.
Upload the module configuration information from the DSM. For additional information, refer to Module Configuration Testing and Inspection.
2. Position the seat to the highest and most-rearward position to increase the ease-of-access to the DSM.
3. Disconnect the DSM electrical connectors.
4. Remove the 2 bolts and the DSM.
5. NOTE: If installing a new DSM, make certain to download the module configuration information to the new module after installation.
To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.