Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Flex AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
Cruise Control Switch
Removal and Installation
1. Remove the driver air bag module. For additional information, refer to Supplemental Restraint System Driver Air Bag Module.
2. Disconnect the electrical connector.
3. Remove the 4 screws and the steering wheel bezel box.
4. Remove the steering wheel bezel box.
1. Remove the 4 screws.
2. Release the top 2 tabs.
3. Release the bottom 2 tabs.
5. NOTICE: Lightly hand-tighten the screws. Do not use power tools. Failure to follow this instruction may result in damage to the steering wheel switch bezel or the steering wheel bezel box.
Remove the 4 screws and separate the steering wheel switch bezel from the steering wheel bezel box.
- Make sure not to break the tabs on the bezels.
6. Remove the 2 screws and the cruise control switch.
7. To install, reverse the removal procedure.
- Make sure the bezels are aligned correctly with the steering wheel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
