2011 Ford Fiesta SES, StandardFACTORY OEM SERVICE PROCEDURE

Interior Lighting

BODY CONTROL MODULE (BCM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1091:12 Courtesy Lamp Sense: Circuit Short To Battery Go to PINPOINT TEST B .
B1175:92 Drivers Door Ajar Switch: Performance Or Incorrect Operation Go to PINPOINT TEST D .
B1176:92 Passenger Door Ajar Switch: Performance Or Incorrect Operation Go to PINPOINT TEST D .
B1178:92 Boot/Trunk Ajar Switch: Performance Or Incorrect Operation Go to PINPOINT TEST C .
B11E9:92 Left Rear Door Ajar Switch: Performance Or Incorrect Operation Go to PINPOINT TEST D .
B11EA:92 Right Rear Door Ajar Switch: Performance Or Incorrect Operation Go to PINPOINT TEST D .
B12F1:11 Ambient Lighting Zone 1 Output: Circuit Short To Ground Go to PINPOINT TEST H .
B12F1:15 Ambient Lighting Zone 1 Output: Circuit Short To Battery Or Open If the ambient lighting is inoperative, go to PINPOINT TEST H . If the ambient lighting is always on, go to PINPOINT TEST J .
B1D14:11 Interior Lights Circuit "B": Circuit Short To Ground Go to PINPOINT TEST B .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.