Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Fiesta L4-1.6LFACTORY OEM SERVICE PROCEDURE
Toe Adjustment - Front
Toe Adjustment - Front
1. Using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
2. Using alignment equipment and the manufacturer's instructions, measure the toe.
3. Loosen the tie-rod end jam nuts.
4. Rotate the tie rods as necessary to adjust the toe setting.
5. Tighten the tie-rod end jam nuts to 85 Nm (63 lb-ft).
6. Recheck the toe settings, adjust as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.