2011 Ford Explorer Limited, FWDFACTORY OEM SERVICE PROCEDURE

Exploded View

Fig 1: Exploded View Of LH Catalytic Converter And Exhaust Pipes
G07430764Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION CHART

Item Service Part Number Description Tool Number Material Name Notes
1 W714133 Left Hand (LH) catalytic converter manifold heat shield bolt (3 required) - - 12 Nm (106 lb-in)
2 9Y427 Left Hand (LH) catalytic converter manifold heat shield - - -
3 W712244 Left Hand (LH) catalytic converter manifold-to-cylinder head stud (6 required) - - 12 Nm (106 lb-in)
4 9448 Gasket - - -
5 - Left Hand (LH) Heated Oxygen Sensor (HO2S) electrical connector (part of 9F472) - - -
6 - Left Hand (LH) Catalyst Monitor Sensor (CMS) electrical connector (part of 9G444) - - -
7 5G232 Left Hand (LH) catalytic converter manifold - - -
8 W701706 Left Hand (LH) catalytic converter manifold-to-cylinder head nut (6 required) - - 25 Nm (18 lb-ft)
9 9450 Gasket - - -
10 W714265 Exhaust Y-pipe-to-Left Hand (LH) catalytic converter manifold nut (2 required) - - -
11 5G274 Exhaust Y-pipe - - -
12 5230 Muffler and tailpipe assembly - - -
Fig 2: Exploded View Of RH Catalytic Converter And Exhaust Pipes
G07430765Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION CHART

Item Service Part Number Description Tool Number Material Name Notes
1 - Right Hand (RH) Catalyst Monitor Sensor (CMS) electrical connector (part of 9G444) - - -
2 W714265 Right Hand (RH) catalytic converter-to-exhaust manifold nut (4 required) - - -
3 5F263 Gasket - - -
4 5E212 Right Hand (RH) catalytic converter - - -
5 W712458 Right Hand (RH) catalytic converter-to-exhaust manifold stud (4 required) - - 25 Nm (18 lb-ft)
6 W714265 Exhaust Y-pipe-to-Right Hand (RH) catalytic converter nut (2 required) - - -
7 5F262 Exhaust Y-pipe isolator - - -
8 5221 Torca® clamp - - 55 Nm (41 lb-ft)
9 5F262 Muffler and tailpipe assembly exhaust isolator (4 required) - - -

Refer to the procedures and/or exploded views in this service information for any Warnings, Notices, Notes, Materials, Specifications, and Special Tools. Items in the exploded views may not be listed in order of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.