Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Explorer Base, AWD, 6F55FACTORY OEM SERVICE PROCEDURE
Side Obstacle Detection Module - Left (SOD-L) and Side Obstacle Detection Module - Right (SOD-R)
SIDE OBSTACLE DETECTION CONTROL MODULE - LEFT (SOD-L) AND SIDE OBSTACLE DETECTION CONTROL MODULE - RIGHT (SOD-R) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | REFER to DIAGNOSTIC ROUTINE D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | REFER to DIAGNOSTIC ROUTINE D . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | REFER to DIAGNOSTIC ROUTINE J . |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | This Diagnostic Trouble Code (DTC) sets when the Side Obstacle Detection Control Module - Left (SOD-L) and/or Side Obstacle Detection Control Module - Right (SOD-R) receives invalid network data from the Body Control Module (BCM) with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This Diagnostic Trouble Code (DTC) sets due to incomplete or improper Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool (REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) for further information). If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U3000:44 | Control Module: Data Failure | REFER to DIAGNOSTIC ROUTINE H . |
| U3000:45 | Control Module: Program Memory Failure | REFER to DIAGNOSTIC ROUTINE H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | REFER to DIAGNOSTIC ROUTINE H . |
| U3000:48 | Control Module: Supervision Software Failure | REFER to DIAGNOSTIC ROUTINE H . |
| U3000:49 | Control Module: Internal Electronic Failure | REFER to DIAGNOSTIC ROUTINE H . |
| U3000:4A | Control Module: Incorrect Component Installed | REFER to DIAGNOSTIC ROUTINE H . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.