2011 Ford Explorer Base, AWD, 6F55FACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATION CHART

Description Part Number Torque
Exhaust Y-pipe-to-Left Hand (LH) catalytic converter manifold nuts W714265 REFER to Exhaust Y-Pipe 
Exhaust Y-pipe-to-Right Hand (RH) catalytic converter nuts W714265 REFER to Exhaust Y-Pipe 
Left Hand (LH) catalytic converter manifold heat shield bolts W714133 12 Nm (106 lb-in)
Left Hand (LH) catalytic converter manifold-to-cylinder head nuts W701706 25 Nm (18 lb-ft)
Left Hand (LH) catalytic converter manifold-to-cylinder head studs W712244 12 Nm (106 lb-in)
RH catalytic converter-to-exhaust manifold nuts W714265 REFER to Catalytic Converter - RH, FWD  or REFER to Catalytic Converter - RH, AWD .
Right Hand (RH) catalytic converter-to-exhaust manifold studs W712458 25 Nm (18 lb-ft)
Torca® clamp 5221 55 Nm (41 lb-ft)
Worm gear clamp 5221 7 Nm (62 lb-in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.