Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Expedition 2WD V8-5.4LFACTORY OEM SERVICE PROCEDURE
Timing Component Alignment Marks: Locations
Timing Component Alignment Marks
For detailed installation procedure see Timing Drive Components. Removal and Replacement
LH
Aligning the timing mark on the outer flange of the crankshaft sprocket with the single copper (marked) link on the chain.
NOTE: Make sure the upper half of the timing chain is below the tensioner arm dowel.
Position the timing chain on the camshaft phaser and sprocket with the timing mark positioned between the 2 copper (marked) chain links.
NOTE: The LH timing chain tensioner arm has a bump near the dowel hole for identification.
RH
Aligning the timing mark on the sprocket with the single copper (marked) chain link.
NOTE: The lower half of the timing chain must be positioned above the tensioner arm dowel.
NOTE: The camshaft phaser and sprocket will be stamped with one of the illustrated timing marks for the RH camshaft.
As a post-check, verify correct alignment of all timing marks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
