Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Expedition 2WD V8-5.4LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
Cruise Control Switch
Expedition
Navigator
Removal and Installation
Expedition
NOTE: It is not necessary to remove the driver air bag module during this procedure.
NOTE: Be careful not to allow the cruise control switch electrical connector to fall back into the steering wheel.
1. Remove the cruise control switch by pulling the switch toward the rear of the vehicle.
- Disconnect the electrical connector.
Navigator
2. Remove the driver air bag module. For additional information, refer to Supplemental Restraint System Driver Air Bag Module.
3. Remove the 2 screws and the steering wheel controls bezel.
4. Remove the cruise control switch by pulling the switch toward the rear of the vehicle.
- Disconnect the electrical connector.
All vehicles
5. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
