2011 Ford Escape 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Service and Repair




Window Control Switch

Factory service manual diagram




Factory service manual diagram




Removal and Installation

NOTE: LH front window control switch shown, all others similar.

NOTE: The removal and installation procedures for all window control switches are similar.

1. Remove the front door trim panel or the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Release the window control switch bezel from the door trim panel.

3. Release the locking tabs and remove the window control switch from the bezel.

4. To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.