Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Edge SEL, FWDFACTORY OEM SERVICE PROCEDURE
Steering Column Control Module (SCCM)
STEERING COLUMN CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1008: 09 | Wiper Mode Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B1051: 09 | Front Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B1052: 09 | Rear Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B10AD:02 | Rain Sensor: General Signal Failure | If the rain sensitive wipers do not operate, GO to PINPOINT TEST G
. If the rain sensitive wipers operate correctly, disregard this DTC. |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F
. If the rain sensitive wipers do not operate, GO to PINPOINT TEST G . |
| B10AD: 49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to RAIN SENSOR . CLEAR the DTCs. REPEAT the self-test. |
| B1131:02 | Wiper Motor Module: General Signal Failure | If the windshield wipers are inoperative in all modes, GO to PINPOINT TEST A
. If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F . If the windshield wipers operate correctly, disregard this DTC. |
| B1131:08 | Wiper Motor Module: Bus Signal/Message Failure | If the windshield wipers are inoperative in all modes, GO to PINPOINT TEST A
. If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F . |
| B12F7: 09 | Single Wipe Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| All other DTCs | - | REFER to STEERING COLUMN SWITCHES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.