Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Edge SEL, FWDFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM)
BCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Drivers Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B1306:01 | Liftgate Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | GO to PINPOINT TEST C . |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are inoperative, GO to PINPOINT TEST C
. If the interior courtesy lamps stay on continuously, GO to PINPOINT TEST F . |
| U1000:00 | Solid State Driver Protection Active - Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Body Control Module (BCM) cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first . After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, INSTALL a new BCM . REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation . |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.