Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE
Side Obstacle Detection Control Module - Left (SOD-L) and Side Obstacle Detection Control Module - Right (SOD-R)
SIDE OBSTACLE DETECTION CONTROL MODULE - LEFT (SOD-L) AND SIDE OBSTACLE DETECTION CONTROL MODULE - RIGHT (SOD-R) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | If the LED is not illuminated GO to PINPOINT TEST D
. If the LED is always on GO to PINPOINT TEST I . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST J . |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | DTC U0422:00 is set when the SOD-L or SOD-R receives invalid network data from the Body Control Module (BCM). RETRIEVE and REPAIR all non-network DTCs in the BCM . REFER to MULTIFUNCTION ELECTRONIC MODULES . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | The Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is not configured. REFER to MODULE CONFIGURATION for Programmable Module Installation (PMI) to configure the SOD-L or SOD-R . CLEAR all DTCs. TEST the system for normal operation. |
| U3000:44 | Control Module: Data Failure | GO to PINPOINT TEST H . |
| U3000:45 | Control Module: Program Memory Failure | GO to PINPOINT TEST H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to PINPOINT TEST H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to PINPOINT TEST H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to PINPOINT TEST H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to PINPOINT TEST H . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.